Fanimation Camview FP6225BL Owner's Manual page 11

How to Assemble the Light Kit and Blade (Continued)
5. Insert light bulb into socket. (Figure 5)
CAUTION
To reduce the risk of fire, use 100-watt max. type
T4-minican JD E11 tungsten halogen bulb. Turn off
the wall switch and allow the bulb to cool for 10
minutes before relamping.
Bulb is pressurized and may shatter. DO NOT
TOUCH BULB WITH BARE HANDS. Fingerprints
may result in shorter bulb life. Remove fingerprints
with alcohol prior to use.
6. Securely attach glass by twisting clockwise onto the
socket plate assembly. Don't overtighten or force it.
(Figure 6)
7. Position the blade over the blade arm with holder
assembly with threaded posts showing. Make sure the
bottom edge of the blade is fully seated against the
flywheel of blade arm with holder assembly. Tighten
the #8-32 x 6 mm washer-head screws with fiber
washers to secure the blade to the flywheel of blade
arm with holder assembly. (Figure 7)
Glass
Blade Arm
with Holder Assembly
HARD WARE USED:
#8-32 x 6 mm
WASHER HEAD
SCREWS
FIBER WASHER
11
Figure 5
Figure 6
#8-32 x 6 mm
Washer Head
Screw and Fiber
Washer (3 each
per blade)
Figure 7
Blade
x 12
x 12