DBLTek ROIP302 Series User Manual page 24

ROIP302 Series User menu
where the password is the GSM OUT Password as described in Section 7.7.
the PTT button is pressed while dialing the sequence.
will then play the voice prompt of "Dialing in Progress".
then broadcast a voice prompt of "Call connected" to the radio caller.
Since the called party may not know the call is coming from a Radio party, the mechanism used in 1
cannot be used. Instead, the voice activated detection (VAD) mechanism is adopted.
is no voice activities on the radio side, voice signal at the telephone side will be transmitted.
Therefore, both sides will have to adapt to this talking method in order to conduct a normal
conversation.
8
Application Examples
Example 1: Linking up two MOTO GM300 Radio terminals in peer-to-peer mode with two
RoIP302/RoIP302G.
Operating procedures:
1. Connect the PTT Interface of the radio terminal (GM300) with the PTT Interface Cable as
shown in the diagram below.
port of the RoIP302.
2. Connect the RoIP302 LAN port to an Ethernet port of the ADSL Router
3. Assign a fixed IP to the RoIP302 LAN port.
the LAN port of the ADSL Router.
192.168.1.1, then the LAN port RoIP302 could be set to 192.168.1.101.
4. Configure the DMZ mode of the ADSL Router to fixed IP assigned to the RoIP302 LAN port.
For DMZ configuration, please refer to the User Manual of the Router.
5. Login to the RoIP Webpage and program the Network Settings as shown below.
that the DNS addresses should be programmed as provided by from your local ISP.
The network access method is ADSL.
Connect the RJ-11 plug of the PTT Interface Cable to PTT1
Once the RoIP accepts the dialed sequence, it
Once the call is answered, the RoIP will
This fixed IP must be in the same segment as
For example: if the LAN of the ADSL Router has an IP
Please make sure that
When there
Please note
www.dbltek.com