Factory Default Settings - DBLTek ROIP302 Series User Manual

ROIP302 Series User menu
iii. Connect the WAN Port to a router, network switch, ADSL/Cable Modem for access an
external network or the public network.
iv. Connect the LAN Port to a local PC or a local Ethernet network (LAN).
the external network connected to the WAN Port with the local network. However, the
shared network is intended for configuration the device and is best not used for high data
traffics applications in order for the device to insure the best voice quality.
5

Factory Default Settings

The table below shows the factory default settings.
default settings:
i. Press the RESET switch for more than 15 seconds.
ii. In the Configuration page, select Tools and then Reset Config.
Item
Login ID
Login Password
WAN Port Setting
LAN Port Setting
PTT State
GSM Login password
PTT maximum duration
Jitter Delay
Factory Default Settings
admin
admin
DHCP
192.168.8.1
"0" is active
123
60 seconds
60 milliseconds
There are two ways to reset to the factory
Range
Programmable (16
characters in the ASCII
table）
"0" is active low
"1" is active high
8 digits or less
Less than 600 seconds
20 – 220 milliseconds
This allows sharing
www.dbltek.com