Ribbon Shield Adjustment - Century Falcon 4 Plus Series User Manual

5-6. Ribbon Shield Adjustment

1. Due to the differences in the ribbon materials, if ribbon wrinkles occur during printing,
please adjust the ribbon shield screw.
Example: If ribbon wrinkles occur as (a), please turn the ribbon shield screw A clockwise, and if
ribbon wrinkles occur as (b), please turn the ribbon shield screw B clockwise.
(a)
2. It is recommended to adjust by a half of a circle each time to fully control the printing
quality and status. Perform the printing test after adjustment, and if a ribbon wrinkle has
not been removed, please perform the adjustment one more time. Each adjustment on
the screw can not be turned more than two circles.
【 】
Note
If the screws are turned more than acceptable range, then paper feed may not be smooth. In
this circumstance, please restore the ribbon shield screws and do the adjustment again.
Falcon 4 Plus/Falcon 6 Plus User's Manual
A
49
(b)
B