Lcd Monitor - Century Falcon 4 Plus Series User Manual

LCD monitor

Press and hold key about 3 to 4 seconds until the buzzer beep 3 times and LCD shows
Setting mode. The LCD monitor will show different options on the bottom.
Below are general descriptions of setting items.
Darkness
Speed
Adjust Stop Position
Printhead Position
Printing mode
Option Setup
Falcon 4 Plus/Falcon 6 Plus User's Manual
After entering to Setting mode, the first
highlight on LCD monitor indicates the
current item for setting.
In setting type, the first line indicates the
current item and the second line indicates
current setting.
In adjustment type, the first line indicates the
current item and the second line indicates
current value.
Plus: press
Minus: press
Next: press
Default: 15
Set the darkness of printing result. The setting value is from 0
to 19 and the default value is 15.
Set the speed of printing.
Default: 0
Set the stop position of printing. The setting value is from 0 to
10.
*Note: When printing with label format that is created based
on old series printers, please change this setting to achieve
the compatibility. Set the value to 3 when printing with cutter;
set the value to 4 when printing with stripper or doing normal
printing.
Default: 0
Set the position of print head when printing. The setting value
is from -100 to 100.
Default: Thermal Transfer
Thermal Transfer: when printing, a ribbon must be installed
to transfer the print contents onto the media.
Direct Thermal: when printing, no ribbon is necessary; it only
requires direct thermal media.
Default: Option OFF
Strip Mode: turn on the stripper function
Cutter Mode: turn on the cutter function
Applicator Mode: turn on the applicator function
None: select this to turn off the stripper and cutter functions.
36
key to increase the value
key to decrease the value
key to go to next item