Setting Mode - Century Falcon 4 Plus Series User Manual

4-3. Setting mode

In the Setting Mode, changes can be made according to requirement on the printing mode,
options, media type, and parallel interface (printer can only go into setting when connected to PC
by parallel cable, USB cable, or serial cable).
1. Power on the printer and make sure it is on "Ready to print" status.
2. Press and hold Pause key about 3 to 4 seconds until the buzzer beep 3 times (for product
types that with LCD monitor, the LCD will display "Setting Mode").
3. In the Setting Mode, the keys have the following functions:
: MINUS / Enter
: MENU / NEXT
: PLUS / Exit
4. Before exiting the Setting Mode, printer will prompt user whether to save the settings. After
user's response on whether do or do not save the settings, printer will return to standby
mode.
LED signal
Press and hold key about 3 to 4 seconds until the buzzer beep 3 times
Blinking
Exit
Setting mode without
saving
Darkness
Speed
Direct Thermal
/ Thermal DT
Transfer
Stop Position
Buzzer Off
Falcon 4 Plus/Falcon 6 Plus User's Manual
Steady
Ribbon
Save &
exit
- +
- +
TT
- +
On
Media
Ribbon & Media lights flash
simultaneously
Ribbon light flashes and then
blinks for each pressing. The
buzzer will beep when the
adjustment reaches the
maximum or minimal.
Media light flashes and then
blinks for each pressing. The
buzzer will beep when the
adjustment reaches the
maximum or minimal.
Ribbon light blinks.
Ribbon light blinks and Media
light flashes. The Media light
blinks for each pressing and
the buzzer will beep when the
adjustment reaches the
maximum or minimal.
Media light blinks
35
Description