Century Falcon 4 Plus Series User Manual page 16

5. Place the label roll onto
the Label Roll Bar and
align the label to
printer's inner wall. (To
avoid the damage of
media, please do not
squeeze label roll too
hard.)
6. Pull the Label
Alignment Guide back
and make it fit the edge
of label roll.
【 】
Note
Please always hold the
bottom of the Label
Alignment Guide when
moving.
7. Follow the direction as
the figure shows to feed
the label.
8. Put the label under the
Moveable Sensor and
stretch it to the Tear-Off
Bar.
【 】
Note
Moveable Sensor should be
aligned to the position of
label gap, black mark and
punch hole. You can adjust
the position with Moveable
Sensor Lever.
Falcon 4 Plus/Falcon 6 Plus User's Manual
3
15
1
2