Century Falcon 4 Plus Series User Manual page 29

3. Hold the cutter and secure the
cutter kit onto the printer.
4. Plug the cutter cable connector
onto the cutter connector.
5. Tie the cables with the secure
locks, and stick the locks onto
the bottom plate.
6. Hang up the cutter cover to the
cutter and screw the bottom
cover screw.
7. Install the media into the printer.
Close the Top Cover to complete
the cutter installation.
【 】
Note1
Make sure the printer is set to
activate cutter function on.
【 】
Note2
The label / paper used for cutting is
suggested to be at least 30mm in
height.
【 】
Suggestion
When installing the cutter module, set
the stop position to 26 (for Falcon 4
Plus) or 30 (for Falcon 6 Plus) in
CLabel and the E value is 26 (for
Falcon 4 Plus) or 30 (for Falcon 6
Plus).
Falcon 4 Plus/Falcon 6 Plus User's Manual
Falcon 4 Plus
28
Falcon 6 Plus