Procedures For Installing The Telephone - Lucent Technologies 6201 Quick Reference

PROCEDURES FOR INSTALLING THE
TELEPHONE
TABLE/DESK INSTALLATION
Use the 7-foot straight line cord that came with your
telephone to connect the telephone to a modular jack.
!
WARNING:
Do not plug the handset cord into the line jack or the
data jack on your telephone since it could damage your
handset and the telephone.
Turn the telephone upside down so that you can see the
1
bottom of the telephone. See Figure 3.
Desktop
stand
Figure 3. The Bottom of the 6200 Series Telephones
Remove the desk stand by sliding it to the left until it is
2
free of the telephone base.
Desktop
stand
Figure 4. Sliding the Base from the Bottom of the Set
Plug one end of the line cord into the line jack on the
3
bottom of the telephone.
Align the other end of the line cord so that it appears
4
through the slot at the top of the stand and reattach the
stand to the telephone by sliding the stand into the
appropriate tabs and then to the right.
Turn the telephone right-side up and place it on your desk
5
or table.
5
Line jack
4 holes for
wall mounting
Slide stand
to left and lift