Dell PowerConnect W-AirWave 7.6 Configuration Manual page 39

Field
Ethernet Interface 0
Link Profile
Ethernet Interface 1
Link Profile
AP System Profile
Regulatory Domain
Profile
SNMP Profile
VoIP Call Admission
Control Profile
802.11g Traffic
Management
Profile
802.11a Traffic
Management
Profile
IDS Profile
Dell PowerConnect W-AirWave 7.6 | Configuration Guide
Default Description
Sets the duplex mode and speed of AP's Ethernet link for ethernet interface 0. The
configurable speed is dependent on the port type, and you can define a separate Ethernet
Interface profile for each Ethernet link.
default
Select the pencil icon next to this field to display the Profiles > AP > Ethernet Link details
page and adjust these settings as desired.
Sets the duplex mode and speed of AP's Ethernet link for ethernet interface 1. The
configurable speed is dependent on the port type, and you can define a separate Ethernet
Interface profile for each Ethernet link.
default
Select the pencil icon next to this field to display the Profiles > AP > Ethernet Link details
page and adjust these settings as desired.
Defines administrative options for the controller, including the IP addresses of the local,
backup, and master controllers, Real-Time Locating Systems (RTLS) server values, and
the number of consecutive missed heartbeats on a GRE tunnel before an AP reboots
traps.
This field is a drop-down menu with the following options:
Non-integer RTLS Server Station Message Frequency
default
l
Too-high RTLS Server Port
l
Too-low AeroScout RTLS Server Port
l
Too-low RTLS Server Port
l
Select the pencil icon next to this field to display the Profiles > AP > System details page
and adjust these settings as desired.
Defines an AP's country code and valid channels for both legacy and high-throughput
802.11a and 802.11b/g radios.
default
Select the pencil icon next to this field to display the Profiles > AP > Regulatory Domain
page and adjust these settings as desired.
Selects the SNMP profile to associate with this AP group. The drop-down menu lists all
SNMP profiles currently enabled in AirWave.
default
Select the pencil icon next to this field to display the Profiles > AP > SNMP page and
adjust these settings as desired.
Voice Call Admission Control limits the number of active voice calls per AP by load-
balancing or ignoring excess call requests. This profile enables active load balancing
and call admission controls, and sets limits for the numbers of simultaneous Session
Initiated Protocol (SIP), SpectraLink Voice Priority (SVP), Cisco Skinny Client Control
default
Protocol (SCCP), Vocera or New Office Environment (NOE) calls that can be handled by a
single radio.
Select the pencil icon next to this field to display the Profiles > AP > Regulatory Domain
page and adjust these settings as desired.
Specify the minimum percentage of available bandwidth to be allocated to a specific
default SSID when there is congestion on the wireless network, and sets the interval between
bandwidth usage reports. This setting pertains specifically to 802.11g.
Specify the minimum percentage of available bandwidth to be allocated to a specific
default SSID when there is congestion on the wireless network, and sets the interval between
bandwidth usage reports. This setting pertains specifically to 802.11a.
Selects the IDS profile to be associated with the new AP Group. The drop-down menu
default contains these options:
ids-disabled
l
Configuration Reference | 33