Wall Control Panel Dip Switch Settings - Bosch PLENA matrix Operation Manual

24 en | Configuration
7.2

Wall Control Panel DIP switch settings

The wall control panel is designed to control either the back ground music inputs or the mic./
line inputs in one specific zone. As such each wall control panel requires an ID to let the DSP
matrix mixer know which unit (or zone) is requesting a change in source or volume. This is
done via DIP IDs switches to allocate a number to the unit and its function. The DIP switches
are located on the backside of the wall control panel.
–
1.
2.
DIP switch
1*
1 OFF ON
2 OFF OFF ON
3 OFF OFF OFF OFF ON
4 OFF OFF OFF OFF OFF OFF OFF OFF ON
* Factory default.
Notice!
A DIP switch in the down position is OFF.
A DIP switch in the up position is ON.
Example:
If all DIP Switches are down/OFF this is ID 1 (Factory default).
If all DIP switches are up/ON this is ID 16.
Notice!
Hardware settings cannot be overruled or changed by the GUI application software.
2013-06 | V1.0 |
There are two sets of IDs that give the wall control panel different functions:
DIP IDs 1‑8 : Line input (background music (BGM)) source selection corresponding to
output zones 1‑8.
DIP IDs 9‑16 : Mic./line input select and mic./line mix mode for output zones 1‑8. (e.g.
ID 9 = Zone 1, ID 16 = Zone 8).
Line input (BGM) source selection
2 3 4 5
OFF ON OFF ON
ON OFF OFF ON
Wall control panel number ID
6 7 8 9 10
OFF ON OFF ON
ON OFF OFF ON
ON ON ON OFF OFF OFF OFF ON
ON
Operation manual
Mic./line mix mode
11 12 13 14 15
OFF ON OFF ON OFF ON
ON OFF OFF ON
ON ON
ON ON ON ON ON
Bosch Security Systems B.V.
PLENA matrix
16
ON
ON
ON