Getac B300 User Manual page 96

Wake Up Capability specifies events for waking up the system from S3
(Sleep) state. Press Enter to access the submenu as shown below.
Information
Any-key Wake Up From S3:
Ring Wake-Up From S3
USB Wake-Up From S3
F1 Help
Esc Exit
Any-key Wake Up From S3 allows any key to wake up the system from
S3 (Sleep) state.
Ring Wake-Up From S3 allows a modem activity to wake up the system
from S3 (Sleep) state.
USB Wake-Up From S3 allow a USB device activity to wake up the
system from S3 (Sleep) state.
System Policy sets the system performance. When set to
CPU always runs at full speed. When set to
according to the current workload, therefore balancing between
performance and power consumption.
AC Initiation sets if connecting AC power will automatically start or resume
the system.
SATA Mode set to
take advantage of Advanced Host Controller Interface features. The options
IDE AHCI
are and
CAUTION: Incorrect SATA mode settings can result in hard disk drive boot
failure.
5-6
Using BIOS Setup and System Recovery
Main Advanced
Wake Up Capability:
[Disabled]
[Disabled]
[Disabled]
Select Item -/+
↑↓
Select Menu Enter
←→
AHCI
if your hard disk supports AHCI. AHCI allows you to
.
Security
Disabled
Change Values
Select Sub-Menu
Balance
Boot Exit
Item Specific Help
Allow any key to wake
up the system from S3
(Sleep) state.
F9 Setup Defaults
F10 Save and Exit
Performance
, the CPU speed changes
, the