Amana AGDS902 Series Owner's Manual page 17

4. Slide cartridge towards rear of range until cartridge
engages range. Lower front of cartridge into well.
5. Place burner caps on burner base.
A
B
A—Burner Grate
B—Burner Bowl
C—Burner Cap
D—Burner Base
Place Burner Caps and Grate
C
D
To make sure cap is properly aligned and leveled, move
burner cap around on burner base. Pegs in the burner
base fit into recess in underside of burner cap. Burner cap
must be correctly seated on burner base for proper
operation of burner.
Make sure proper cap size is on each burner base.
Burner does not burn properly if wrong size burner cap is
placed on burner base.
Not centered
Position Burner Caps
6. Ignite burner. Properly adjusted burner flames are
clean and blue with a distinct inner cone
approximately ½ inch long.
• If burner flame is blowing or noisy, or if burner flame
is yellow and does not hold its shape, see
"Adjusting Burner Flame Characteristics" section.
7. Replace burner grate when flame is properly adjusted.
17
Correct
Too small Too large