Installing The Tie-Rods - Yamaha YFM50S Service Manual

STEERING SYSTEM
EBS00465

INSTALLING THE TIE-RODS

The following procedure applies to both of the
tie-rods.
1. Install:
• tie-rod
NOTE:
_
• The tie-rod side which must be installed on
the inside has grooves 1.
• When installing the tie-rod, hold each tie-rod
ball joint with a 14-mm wrench 2 and then
tighten the tie-rod end nut.
2. Adjust:
• toe-in
Refer to "ADJUSTING THE TOE-IN" in
chapter 3.
7 - 23
CHAS
15 Nm (1.5 m · kg, 11 ft · lb)