Installing The C.d.i. Magneto Rotor; Installing The Shift Lever - Yamaha YFM50S Service Manual

1
EBS00268

INSTALLING THE C.D.I. MAGNETO ROTOR

1. Install:
NOTE:
_
• Before installing the rotor, clean the outside
• After installing the rotor, check that the rotor
2
2. Tighten:
NOTE:
_
• While holding the C.D.I. magneto rotor 1
• Do not allow the sheave holder to touch the

INSTALLING THE SHIFT LEVER

1. Install:
a
NOTE:
Temporarily install the left footrest board, and
then install the shift lever and align it with the
mark a on the left footrest board.
4 - 32
C.D.I. MAGNETO
• woodruff key
• C.D.I. magneto rotor
of the crankshaft and the inside of the rotor.
rotates smoothly. If not, reinstall the key and
rotor.
• C.D.I. magneto rotor nut
40 Nm (4.0 m · kg, 29 ft · lb)
with the sheave holder 2, tighten the C.D.I.
magneto rotor nut.
projection on the rotor.
Sheave holder
P/N. YS-01880-A, 90890-01701
• shift lever
ENG