REAR AXLE/FINAL DRIVE ASSEMBLY AND DRIVE
SHAFT
REMOVING THE NUTS
1. Place the machine on a level surface.
2. Loosen:
• nuts 1
NOTE:
_
• Apply the rear brake lever so that the rear
axle does not turn, when loosening the nuts.
• Use an axle nut wrench (36 mm).
Axle nut wrench (36 mm)
P/N. YM-37132, 90890-01422
3. Elevate the rear wheels by placing the suit-
able stand under the frame.
4. Remove:
• rear wheels
• wheel hubs
• nuts
5. Remove:
• rear brake assembly
Refer to "FRONT AND REAR BRAKES" in
chapter 7.
REMOVING THE REAR AXLE/FINAL DRIVE
ASSEMBLY
1. Remove:
• rear axle/final drive assembly 1
NOTE:
Remove the rear axle/final drive assembly as
an assembly after removing each bolt and nut.
6 - 8
DRIV