Rs-232C Interface Model - Star TSP650 Manual

11-2. RS-232C Interface Model
ON
OFF
No. 1 2 3 4 5 6 7 8
Switch 1-1
The factory settings of DIP switch are all on.
The functions of switches 1-2 through 1-8 will change according to the command emulation
that has been set using switche 1-1.
(1) Star mode
Switch
1-1 Command emulation
1-2 Should not be changed (Should be set to on)
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment
1-5 Should not be changed (Should be set to on)
1-6 Handshaking conditions
(conditions for BUSY)
1-7 ASB function *1
1-8 Should not be changed (Should be set to on)
(2) ESC/POS mode
Switch
1-1 Command emulation
1-2 Graphic adjustment
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment
1-5 Should not be changed (Should be set to on)
1-6 Handshaking conditions
(conditions for BUSY)
1-7 ASB function *1
1-8 Should not be changed (Should be set to on)
*1 ASB Function
When this function is enabled, status information is automatically sent to the host whenever the
printer status changes (such as when the cover is opened, paper runs out, or an error occurs).
For information about automatic status information transmission, refer to the separate Program-
mer's Manual (Star Line Mode and ESC/POS Mode).
ON
OFF
DIP-SW 1
ON
OFF
Function
Function
No. 1 2 3 4
DIP-SW 2
DIP-SW 1
Command emulation
Always ON
Invalid
Offline or receive
buffer full
Invalid
Always OFF
203 DPI
Invalid
Offline or receive
buffer full
Invalid
– 36 –
Star Mode
ESC/POS Mode
ON
Valid
Receive buffer full
Valid
ON
180 DPI
Valid
Receive buffer full
Valid
OFF
OFF