Rs-232C Connector - Star TSP650 Manual

13-2. RS-232C Connector
Signal
Pin No.
1
2
3
4
5
6
7
8~19
20
Direction
name
F-GND —
TXD OUT
RXD IN
RTS OUT
N/C
DSR IN
S-GND —
N/C
DTR OUT
Frame ground
Transmission data
Receive data
Always SPACE
Not used.
1) STAR Mode
Not used.
2) ESC/POS Mode
When DIP Switch 3-7 = OFF;
A) DTR/DSR communication mode
Indicates whether data receive from host is enabled or
disabled.
Space: Receive enabled
Mark: Receive disabled
(except when transmitting data by DLE EOT, and GS a)
B) X-ON/X-OFF communication mode
Status of this signal is not checked.
When DIP Switch 3-7 = ON;
This is an externally reset signal.
A space above 1 ms pulse width engages reset.
Signal ground
Not used.
1) STAR Mode
A) DTR/DSR communication mode
Indicates whether data receive from host is enabled or
disabled.
Space: Receive enabled
Mark: Receive disabled
B) X-ON/X-OFF communication mode
Always space, except during following conditions:
• Period between reset and communication ena-
bled
• During self printing
– 46 –
Function