Installation - Kenwood KDGMPV7019 Instruction Manual

W Installation
W Installing in Japanese-Made Cars
Firewall or metal support
Screw (M4X8)
1
Refer to the section "Removing
the hard rubber frame" (page 31)
and then remove the hard rubber frame.
2 Align the holes in the unit (two locations on each side) with the
vehicle
mounting bracket
and secure the unit with the accessory
screws.
Bend the tabs of the
mountrng sleeve
wrth a screwdnver or
srmrlar utensrl and
7 Toyota cars
N: Nissan cars
\
Accessory@ ..for Nissan car
Accessory@ for Toyota car
Self-tapprng screw
Metal mounting strap
attach It rn place.
(commercrally avarlablel
(commercrally avariable)
Make sure that the unit IS rnstalled securely in place. If the unrt IS
unstable, It may malfunctron (for example, the sound may skip).
A
l
During rnstallatron, do not use any screws except for those provided
The use of drfferent screws might result in damage to the marn unit
l
Damage may occur If a screwdriver or srnlrlar tool IS used with
excessrve force durrng the Installations.
n Screwing the Faceplate on the Unit
If you want to fasten the
faceplate to the main unit so
that it does not fall
off,
screw in the provided
screws (04 X 16 mm) in the
holes shown below.
A
Never insert the taptite screw (04 x 16 mm) rn any other screw hole
than the one specrfred If you screw It II- another hole, It will contact
and may cause damage to the mechanical parts Inside the unrt
- 30 -