Table of Contents
Advertisement
ACCESSORIES AND INSTALLATION
m™ ACCESSORIES
:
Number of
Part name
External View
Detachable case
Hex. bolt (M5
x 35)
Hex. nut (M5)
Rubber bush
@ INSTALLATION
1. Before installation and wiring, remove the © terminal of the battery to prevent short-
circuiting.
. Connect the input and output cords of the system.
. Connect the ground to the metal chassis of the car.
. Connect the memory
backup lead (yellow).
. Connect the power supply lead (red).
. Install the set and after confirming the installation and wirings are correct, connect
the © terminal of the battery.
7. After installation, surely press the Reset button.
e
lf a fuse is blown, first check that the associated wires
are not short-circuited then replace the fuse with anew
one having the same capacity.
¢
Secure unconnected wires properly so that they do not
contact the vehicle chassis.
¢
Do not remove the caps attached to the unused
a
terminals.
F
e
As the unit uses BTL output, always connect the without stripe speaker wires to the
© terminals of the speaker systems. Never let the © speaker wires touch and never
connect them to the chassis (ground). Do not let the speaker terminals come into
contact with the chassis (ground). Insulate any unused output wire to prevent a short
circuit.
Om
WhHN
(Ex) 29
Advertisement
Table of Contents
