Kenwood KDGMPV7019 Instruction Manual page 11

Adjustment Item Display Range
Bass Center Frequency "Bas F"
60/70/80/l 00 or 150 Hz
(KDC-X459 only)
Bass level
"Bas"/"BAS" -8 - +8
Bass Q Factor "BasQ"
1.00/l .25/l .50/2.00
(KDCX459 only)
Bass Extend
"BasEX"
ON/OFF
(KDCX459 only)
Middle Center Frequency "MidF" 0.5/l .0/l .5/2.0 kHz
(KDCX459 only)
Middle level "Mid"/"MID" -8 - +8
Middle Q Factor
"MidQ"
1.0/2.0
(KDC-X459 only)
Treble Center Frequency "TreF" 10.0/l 2.5/l 5.0/l 7.5 kHz
(KDC-X459 only)
Treble level "Tre"/"TRE" -8 - +8
Balance
"Bal"/"BAL"
Left 15 - Right 15
Fader "Fad"/"FAD" Rear 15 - Front 15
Volume offset "V-OFF"
-8 - *O
@
l
According to the Bass Q Factor setting value. the frequencies that
can be set in Bass Center Frequency change as shown below
Bass Cl Factor Bass Center Frequency
1 00/l 2511.50
60/70/80/l 00
2 00 60/70/80/l 50
* When the Bass Extend IS set to ON, low frequency response IS
extended by 20%
* Volume offset Each source's volume can be set as a difference
from the basic volume
5 Exit Audio Control mode
Press the [AUDI button.
Fine-tuning so that the System Q value is optimal when setting
the speaker type.
1
Enter Standby
Press the [SRCI button.
Select the "ALL OFF" display.
2 Enter Speaker Setting mode
Press the [Ql button.
3 Select the Speaker type
Press the [IAN] or [WH] button.
Each time the button is pressed the setting switches as shown
below.
Speaker type
Display
OFF "SP OFF"
For 5 & 4 In. speaker
"SP 514"
For 6 & 6x9 in. speaker
For the OEM speaker
"SP 6"9/6"
"SP OEM"
4 Exit Speaker Setting mode
Press the [Ql button.
-ll-