Kenwood KDGMPV7019 Instruction Manual page 35

The messages shown below display your systems
condition.
MECHA ER:
EJECT: No disc magazine has been loaded in the changer,
The disc magazine is not completely loaded.
13 Load the disc magazine properly.
No CD in the unit.
6 Insert the CD.
HOLD ER:
No Disc/NO DISC:
No disc has been loaded in the disc magazine.
c; Load a disc into the disc magazine.
TOC ER:
No disc has been loaded in the disc magazine.
r, Load a disc into the disc magazine.
The CD IS quite dirty. The CD is upside-down. The CD
IS scratched a lot.
NO NAME:
3 Clean the CD and load It correctly.
NO TITLE:
E-05:
The CD is upside-down.
1: Load the CD correctly.
NO TEXT:
BLANK: Nothing has been recorded on the MD.
NO TRACK: No tracks are recorded on the MD, although It has a
title.
E-l 5. Media was played that doesn't have data recorded
that the unit can play
I: Use medra that has data recorded that the unrt can
Nav.
LOAD:
NO ACCESS:
IN (Blink):
NO PANEL:
The faceplate of the slave unit berng connected to
this unrt has been removed.
1: Replace it.
E-77: The unrt is malfunctioning for some reason.
a:, Press the reset button on the unit. If the "E-77"
code does not disappear, consult your nearest
service center.
Something is wrong with the disc magazine. Or the
unit is malfunctioning for some reason.
o Check the disc magazine. And then press the reset
button on the unit. If the "MECHA ER" code does
not disappear, consult your nearest service center.
The protective circurt in the unit activates when the
temperature inside the automatic disc changer
exceeds 60°C (140°F). stopping all operation.
0: Cool down the unit by opening the windows or
turning on the air conditioner. As the temperature
falls below 60°C (14O"F), the disc will start playing
again.
Attempted to display DNPS during the CD play having
no disc names preset.
Attempted to drsplay the disc title or track title while
the MD having no MD title is being played.
l
Attempted to display the disc text or track text
while the CD having no CD text is being played.
l
Attempted to display the ID3 tag while the MP3
havrng no ID3 tag is being played.
Discs are being exchanged in the Disc changer
After settrng It in the Disc Changer, DNPP was done
without having it been played at least 1 time.
The CD player section is not operating properly.
*: Reinsert the CD. If the CD cannot be ejected or the
display continues to flash even when the CD has
been properly reinserted, please switch off the
power and consult your nearest service center.
- 35 -