Kenwood KDGMPV7019 Instruction Manual page 4

To prevent injury or fire, take the
following precautions:
l
Insert the unit all the way in until it is fully
locked in place. Otherwise it may fall out of
place when jolted.
l
When extending the ignition, battery, or
ground wires, make sure to use automotive-
grade wires or other wires with a 0.75mm2
(AWGI 8) or more to prevent wire
deterioration and damage to the wire
coating.
l
To prevent a short circuit, never put or leave
any metallic objects (such as coins or metal
tools) inside the unit.
l
If the unrt starts to emit smoke or strange
smells, turn off the power immediately and
consult your Kenwood dealer.
l
Make sure not to get your fingers caught
between the faceplate and the unit.
l
Be careful not to drop the unrt or subject It to
strong shock.
The unrt may break or crack because it
contains glass parts.
l
Do not touch the liqurd crystal flurd if the
LCD is damaged or broken due to shock. The
liquid crystal fluid may be dangerous to your
health or even fatal.
If the liqurd crystal flurd from the LCD
contacts your body or clothing, wash It off
with soap Immediately
1 ACAUTION 1
To prevent damage to the machine,
take the following precautions:
l
Make sure to ground the unit to a negative
12V DC power supply.
l
Do not open the top or bottom covers of the
unit.
l
Do not install the unit in a spot exposed to
direct sunlight or excessive heat or humidity.
Also avoid places with too much dust or the
possibility of water splashing.
l
Do not subject the faceplate to excessive
shock, as it IS a piece of precision
equipment.
l
When replacing a fuse, only use a new one
with the prescribed rating. Using a fuse with
the wrong rating may cause your unit to
malfunction.
l
To prevent a short crrcuit when replacing a
fuse, first disconnect the wiring harness.
l
Do not place any object between the
faceplate and the unit.
l
Do not use your own screws. Use only the
screws provided. If you use the wrong
screws, you could damage the unrt.
l
Do not apply excessrve force to the open
faceplate or place objects on It Doing so will
cause damage or breakdown.
IMPORTANT INFORMATION
About the disc changer/CD player to
be connected:
To connect a disc changer having the "O-N"
switch to this unit, set the "O-N" switch to "N".
To connect a disc changer having no "O-N"
switch to this unit, the converter cord CA-
DSI 00 and/or switching adapter KCA-S21 OA
are required as options.
A disc changer doesn't work when it is
connected without usrng these options.
If a model with no "O-N" switch is connected,
some unavailable functions and information
that cannot be displayed are generated.
Note that none of the KDC-CIOO, KDC-C302,
C205, C705, and non-Kenwood CD changers
can be connected.
A
You can damage both your unit and the CD
changer If you connect them Incorrectly
Do Not Load 3-in. CDs in the CD slot
If you try to load a 3 in. CD with its adapter
into the unit, the adapter might separate from
the CD and damage the unit.
-4-