Power Wheels L2170 Owner's Manual page 9

Ridge
2
FRONT VIEW
• Fit the seat into the vehicle. Make sure the front edge of the seat is
over the ridge in the vehicle.
Screws
3
• Insert two screws into the seat area and four screws in the seat
back. Tighten the screws.
Seat
Screws
PUSH
4
• Position the sport bar so that the screw holes near each end face
the rear of the vehicle.
• Fit the ends of the sport bar into the slots in the top side of
the vehicle.
• Push down on both ends of the sport bar to "snap" into place.
This may take extra force.
Hint: The sport bar is designed to fit one way. If you cannot "snap"
it into place, turn it around and try again!
Cargo Bed
Screws
5
BACK VIEW
• Insert two screws through the cargo bed and into the ends of the
sport bar. Tighten the screws.
9 9
PUSH
Sport Bar
Slots
L2170pr-0920 L2170pr-0920