Power Wheels L2170 Owner's Manual page 10

Hood Strap
6
SIDE VIEW
Hint: Remove the tape holding the hood to the vehicle.
• Pull the hood straps down and then out to unfasten them from the
button on each side of the vehicle.
• Lift the hood open.
Dashboard
7
Hint: The windshield and dashboard come factory assembled and
taped. If these parts come apart after removing the tape, follow this
assembly step.
• Fit the ends of the windshield into the groove and onto the peg on
each side of the dashboard.
Hood
Windshield
Groove
Peg
PUSH
PUSH
Slot
8
• Insert the ends of the windshield/dashboard assembly into the slots
in each side of the vehicle.
• Push down on both ends of the windshield to "snap" it into place.
This may take extra force.
Hint: The windshield/dashboard assembly is designed to fit one way.
If you cannot "snap" it into place, turn it around and try again!
9
• Insert four screws through the dashboard and into the front end of
the vehicle. Tighten the screws.
10 10
Windshield/Dashboard
Assembly
Slot
Screws
Dashboard
FRONT VIEW
L2170pr-0920 L2170pr-0920