Power Wheels L2170 Owner's Manual page 11

Screws
10
DASH VIEW
• First, insert a screw through each side of the vehicle and into the
ends of the windshield/dashboard. Tighten the screws.
• Next, insert two screws through the inside of the vehicle and into
the windshield/dashboard. Tighten the screws.
Washers
Screws
Clip
Shovel
11
FRONT VIEW
• Using safety scissors, carefully cut the plastic tie holding the shovel
and clip together.
Note to Retailer: Do not cut the plastic tie. The plastic tie holds the
shovel in place for display purposes.
• Place the clip and shovel assembly onto the hood.
• First, slide a washer onto the remaining screws. Then, insert the
four screws with washers through the underside of the hood and
into the clip. Tighten the screws.
Screws
Hood
11 11
Hood Strap
12
SIDE VIEW
• Lift and lower the hood closed.
• Pull the hood strap down and over the button on each side of the
front end of the vehicle.
Flat Side of Steering Wheel
13
SIDE VIEW
• Position the steering wheel assembly so that the flat side of the
steering wheel is down.
• Fit the steering column down through the hole in the dashboard
and then out through the hole in the floor of the vehicle.
Hint: You may need to turn the steering column to clear the
windshield and to fit it through both openings.
Hood
Button
Steering Column
L2170pr-0920 L2170pr-0920