Installation Method - Sharp IV-08MTV Instruction Manual

Secure the Monitor using the mounting bracket (Monitor accessory) in the mounting holes on the Monitor
housing (4 positions). For specific external dimensions, see Section 4. "Name and Function of Each Part",
in this manual.
1) Cut a rectangular hole (222 0.5 x 179 0.5 mm) in the control panel (thickness: Max. 7 mm) and
install the Monitor housing in this hole.
Mounting hole in the
mounting bracket
(4, including 2 on
the bottom)
IV-08MTV
2) Insert a mounting bracket (2 each at the top and bottom) into each mounting hole on the housing, and
secure the mounting brackets using the mounting screws.

5. Installation Method

Max. 7 mm
Installation section
53.3 mm
5.6 mm
(Cross-section from position A in the figure above)
Installation section
A
(See the cross section view below)
Mounting bracket
Mounting screw
Mounting holes of the mounting brackets
(totally 4 including top and bottom sides)
- 7 -