Computer Input; Input Source Selection - Sanyo PLC-WXL46A Owner's Manual

Computer Input

Input Source Selection

Direct Operation
Select either Computer 1 or Computer 2 by pressing the
INPUT button on the top control or the COMPUTER button
on the remote control.
Before using INPUT or COMPUTER button, select the
correct input source through Menu operation as described
below.
Menu Operation
1 Press the MENU button to display the On-Screen
Menu. Use the Point ◄► buttons to move the red
frame pointer to the Input Menu icon.
Use the Point ▲▼ buttons to move the red arrow
2
pointer to either Computer 1 or Computer 2, and then
press the SELECT button.
3 After the Source Select Menu appeared for Computer
1, move the pointer to RGB and then press the
SELECT button.
Note:
• Computer 2 is not displayed when the COMPUTER IN 2/
MONITOR OUT terminal is set as Monitor out (p.44).
• Computer 2 (COMPUTER IN 2/MONITOR OUT) can
accept only the RGB signal.
• When the Input Search function is set On1 or On2, the
input signal will be searched automatically (p.44)
Top Control
INPUT button
Remote Control
COMPUTER button
*See Notes at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer (red arrow)
to Computer 1 and press the
SELECT button.
Computer
1
Source Select Menu
Move the pointer to RGB
and press the SELECT
button.
Input Menu
Move the pointer (red arrow)
to Computer 2 and press the
SELECT button.
INPUT button
Computer 1
Computer 
*
Video
COMPUTER button
Computer 1
Computer 
*
5