Table of Contents
Advertisement
Settin�
Ceilin�
When this function is set to "On", the picture is top/bottom
and left/right reversed. This function is used to project the
image from a ceiling-mounted projector.
Rear
When this function is set to "On", the picture is left/right
reversed. This function is used to project the image to a
rear projection screen.
Screen aspect
This function is used to project the image to a 4:3 or 16:9
projection screen.
4:3 ..... Set to a 4:3 projection screen.
16:9 ..... Set to a 16:9 projection screen.
16:10 ....16:10 is the aspect of the LCD panel. The orignal
Screen Menu is available.
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the back
of the projector is switchable for computer input or monitor
output (p.9). Select Computer 2 or Monitor Out with the
Point ◄► buttons.
Computer 2......computer input
Monitor Out......monitor out
Terminal function is not available when Computer 2 to the
input source is selected. Change the input source to the
others (Computer1 or Video) so that the Terminal function is
available (pp.25, 34–35).
Input search
This function detects the input signal automatically. When
finding a signal, the search will stop. Use the Point ◄►
buttons to select one of the following.
Off ...... Input search does not work.
On1 ...... Input search works under the situation below.
• When the COMPUTER button or VIDEO button
on the remote control is pressed.
On2 ...... Input search works under the situation below.
• When the projector is turned on with pressing the
POWER ON/STAND-BY button on the remote
control. (After the countdown)
• When the COMPUTER button or VIDEO button
on the remote control is pressed.
•When the current input signal is missed.
If the No show or Freeze function is active, cancel it
to activate the Input search. It is not available when
On-Screen menu is displayed.
44
Ceilin�
Rear
Note:
• When the 4:3 or 16:9 function is selected,
True and D.Zoom+/- are not available in
the PC screen (pp.32-33).
• When the 4:3 or 16:9 function is selected,
Zoom, Natural wide and Wide are not
available in the AV screen (p.40).
Note:
• While Input search is set On1 or On2, the
status of Input and Lamp are displayed
every time the signal is switched.
• Only the input source selected at the last
time can be detected.
• If COMPUTER/VIDEO button on the
remote control is pressed during Input
search is in progress, Input search will
stop.
Advertisement
Table of Contents
