Video Input; Input Source Selection (Video, S-Video) - Sanyo PLC-WXL46A Owner's Manual

Video Input

Input Source Selection (Video, S-video)

Direct Operation
Select Video by pressing the INPUT button on the top
control or the VIDEO button on the remote control.
Before using INPUT or VIDEO button, select the correct
input source through menu operation as described below.
Menu Operation
1 Use the MENU button to display the On-Screen Menu.
Press the Point ◄► buttons to move the red frame
pointer to the Input Menu icon.
Use the Point ▲▼ buttons to move the red arrow
2
pointer to Video and then press the SELECT button to
display the Source Select Menu .
3 Move the pointer to the desired source and then press
the SELECT button.
When selecting "Auto," the projector
Auto
automatically detects the incoming video signal,
and adjusts itself to optimize its performance.
The projector selects connection in the following
order:
1. S-video
2. Video
When the video input signal is connected to the
Video
VIDEO jack, select Video.
When the video input signal is connected to the
S-video
S-VIDEO jack, select S-video.
Note:
• Computer 2 is not displayed when the COMPUTER IN
2/MONITOR OUT terminal is set as Monitor out (p.44).
•When the Input Search function is set On1 or On2, the
input signal will be searched automatically (p.44).
4
Top Control
INPUT button
*See Notes at the bottom of this page.
Remote Control
VIDEO button
Input Menu icon
Input Menu
Move the pointer to Video and
press the SELECT button.
VIDEO
Source Select Menu (VIDEO)
Move the pointer to the
desired source and press
the SELECT button.
INPUT button
Video
Computer 1
*
Computer 
Video