Kpw937A4> Air Direction Adjustment Grille - Daikin J-Series Engineeiring Data

Optional Accessories
13.4 <KPW937A4> Air Direction Adjustment Grille
 Before Installation
Checking the parts
 Installation Procedure
Selection of Installation Location
Use when installing in a location that meets the following conditions.
When installing near the border to a neighbor's house
If exhaust blows directly on passers-by because outdoor unit is installed facing a road.
Changing the fan direction of the outdoor unit to prevent it blowing directly on shrubbery, etc.
Installation of Louver
Installation is possible in the four directions:
upward, downward, rightward, and leftward.
The installation screws are attached to the louver.
First temporarily attach the louver with 4 screws,
then check that the angle is correct, and finally
tighten the screws fully.
CAUTION
1.Install so that a short circuit is prevented.
2.For the use in snowy regions, avoid installation
with the air outlet facing upward. Install so that
the air outlet faces leftward, rightward, or down-
ward.
Snow accumulates in the air outlet of the outdoor
unit, causing malfunction of the main body of the
outdoor unit.
3.Be advised that if the fan direction is up,
dead leaves and other foreign matter
easily accumulates in the exhaust vent.
96
Check the following parts
Name Louver Installation manual
Shape
With 4 screws
Quantity
1piece 1piece
Prepared hole
pitch 435mm
Fan partition
The prepared hole is in between the grating
of the grille. Part A (prepared hole) cross
section (the shape of either a or b)
a)
Grille grating
Prepared hole
EDUS041016
Prepared hole
pitch 435mm
Fan partition
Part A
(see figure below)
b)
Grille grating
Prepared hole
4P104499-1A
Room Air Conditioners J-Series