Cisco 7916 Phone Manual page 9

Connect the Support Bar to the Cisco Unified
IP Phone
Refer to Figure 3 and the steps that follow.
Figure 3 Connecting the Support Bar
Position the support bar on the back of the
Step 1
Cisco Unified IP Phone so that it fits flush with the
phone.
Locate the two connector pins.
Step 2
Use a flat head screwdriver to carefully push each of the
Step 3
connector pins so that the support bar is firmly fastened
to the Cisco Unified IP Phone.
Connect the Expansion Module 7916 to the
Support Bar
Refer to Figure 4 and the steps that follow.
9