Cisco 7916 Phone Manual page 11

Unified ip phone expansion module
Hide thumbs Also See for 7916:
Table of Contents

Advertisement

Insert the hooks into the slots and then rotate the top
Step 3
of the Cisco Unified IP Phone Expansion Module 7916
into the support bar so that it rests flush with the bar.
Tighten the thumbscrew on the back of the
Step 4
Cisco Unified IP Phone Expansion Module 7916.
Note
Connect the Interface Cable
Refer to the following table, which depicts the "in" and "out"
icons on the AUX jacks, and to Figure 5 and the steps that
follow.
Figure 5
"In" and "Out" Icons on the AUX Jacks
In icon
Plug one end of the interface cable into the jack labeled
Step 1
AUX on the Cisco Unified IP Phone.
Plug the other end of the interface cable into the AUX
Step 2
jack with the "in" icon underneath on the
Cisco Unified IP Phone Expansion Module 7916.
Note
If you are installing two Expansion Modules,
repeat Steps 2, 3, and 4 for the second
Expansion Module.
Out icon
If you are installing a second Cisco Unified
IP Phone Expansion Module 7916, continue
with Steps 3 and 4. Otherwise go to the
"Connect the Power Supply Unit" section on
page 12.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents