Table of Contents
Advertisement
Flow Control [Hardware [Hardware RTS/CTS]
Flow control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a "stop" signal can be sent to stop the data flow. Once the
buffers are empty, a "start" signal can be sent to re-start the flow. Hardware flow control
uses two wires to send start/stop signals. Configuration options: [None] [Hardware
RTS/CTS]
VT -UTF8 Combo Key Support [Enabled]
This allows you to enable the VT -UTF8 Combination Key Support for ANSI/VT100
terminals. Configuration options: [Disabled] [Enabled]
Recorder Mode [Disabled]
This allows you to enable or disable the Recorded mode to capture Terminal data.
Configuration options: [Disabled] [Enabled]
Resolution 100x31 [Enabled]
This allows you to enable or disable the extended terminal resolution. Configuration
options: [Disabled] [Enabled]
Legacy OS Redirection Resolution [80x24]
This allows you to set the number of rows and columns supported on the Legacy OS.
Configuration options: [80x24] [80x25]
Putty Keypad [VT100]
This allows you to select the Function Key and Keypad on Putty. Configuration options:
[VT100] [LINUX] [XTERMR6] [SCO] [ESCN] [VT400]
Redirection After BIOS POST [Bootloader]
This setting allows you to specify if Bootloader is selected than Legacy console
redirection. Configuration options: [Always Enable] [Bootloader]
Serial Port for Out-of-Band Management/Windows Emergency Management
Services (EMS) Settings
These settings specify how the host computer and the remote computer will exchange
data. Both computers should have the same or compatible settings.
Out-of-Band Mgmt Port [COM1]
This item only appears when you set the Console Redirection to [Enabled]. Allows
remote management of a Windows Server OS through a serial port. Configuration
options: [COM1] [COM2]
Terminal Type [VT-UTF8]
This item only appears when you set the Console Redirection to [Enabled]. Allows you
to set the terminal type for out-of-band management. Configuration options:
[VT100]
[VT100+]
[VT-UTF8]
[ANSI]
5-26
ASCII character set.
Extends VT100 to support color, function keys, etc.
Uses UTF8 encoding to map Unicode characters onto
1 or more bytes
Extended ASCII character set
Chapter 5: BIOS setup
Advertisement
Table of Contents
