Table of Contents
Advertisement
2.
VGA controller setting (3-pin VGA_SW1)
This jumper allows you to enable or disable the onboard VGA controller. Set to pins 1–2
to activate the VGA feature.
3.
LAN controller setting (3-pin LAN_SW1, LAN_SW2)
These jumpers allows you to enable or disable the onboard Intel
controllers. Set to pins 1-2 to activate the Gigabit LAN feature.
4.
RAID configuration utility selection (3-pin RAID_SEL1)
This jumper allows you to select the RAID configuration utility for creating disk arrays.
Place the jumper caps over pins 1–2 if you want to use a Third-Party Setup Utility
(default). Otherwise, place the jumper caps to pins 2–3 to use the Intel
Technology.
4-8
I210AT Gigabit LAN
®
®
Chapter 4: Motherboard information
Rapid Storage
Advertisement
Table of Contents
