Table of Contents
Advertisement
7.
Carefully place the 3.5-inch Serial ATA
HDD and HDD drive tray assembly into
the drive bay.
Ensure that no cables or connectors is
out-of-place.
8.
Secure the HDD drive tray and the
3.5-inch SATA HDD assembly to the
HDD bay 2 using the four screws
removed in step 2
Ensure that screw holes on the HDD
drive tray and the 3.5-inch SATA HDD
assembly matches the screw holes on
the HDD bay 2 .
9.
Get the ODD and slide it back into the
optical disc drive slot.
10.
Secure the ODD and the HDD drive
tray to the HDD bay 2 using the screw
removed in step 1.c.
11.
Connect the ODD signal cable and
power cable to the optical disk drive.
2-20
Chapter 2: Hardware setup
Advertisement
Table of Contents
