Axis Q6042-S PTZ Installation Manual page 21

AXIS Q60-S Series
NOTICE
NOTICE NOTICE
• Make sure the connections to the mains supply and conduits have been installed by a
trained professional, according to the manufacturer's instructions and in compliance
with local regulations.
• The power supply (sold separately) and the media converter switch shall be installed in an
environment protected against dust and water, for example indoors or in an appropriate
cabinet.
• The product shall be connected using a shielded network cable (STP) or an optical fiber
cable. All cables connecting the product to the network shall be intended for their
specific use. Make sure that the network devices are installed in accordance with
the manufacturer's instructions. For information about regulatory requirements, see
Regulatory Information, on page 2 .
Important
Axis can only guarantee full functionality with the supplied media converter switch. No
other devices are supported.
1. Make sure the mains supply is switched off.
2. Mount the power supply and the media converter switch on the wall or, if applicable,
attach them to a DIN rail in the cabinet. If drilling is required, make sure to use drill bits,
screws, and plugs that are appropriate for the material.
3. Loosen the screws and remove the cover from the media converter switch.
1
Screw (2x)
2
Cover
3
Media converter switch
4. Strip off 40 mm (1.57 in) of the multi-connector cable jacket.
21