Recheck The Installation - Magma CB264 User Manual

M A G M A
Carefully route the cable to the rear side of the expansion chassis and
attach it to the 68-pin connector, as shown below:
Secure the cable with the captive thumbscrews. It is important that the
cable be attached securely to the connectors at both ends.
Secure the cable with the captive thumbscrews. It is important that the
cable be attached securely to the connectors at both ends.
Before connecting the power cord, check that the expansion chassis
On/Off switch is set to the OFF position. This switch is located on the
right side of the front of the chassis.
NOTE
If at all possible, plug all power cords from the Magma expansion
chassis and your host computer into a shared power strip,
preferably one that has surge and noise suppression circuitry built
into it.

Recheck the Installation

Check your installation before powering up the Magma expansion
chassis for the first time. Although the power supply has an over voltage
protection device built into it, it may not "trip" in time to fully protect a
device that has been improperly connected, or whose power cable has
been damaged.
6
Chapter 2 Hardware Installation