Before You Begin - Magma CB264 User Manual

M A G M A

Before you Begin

The 90 Watt AC power supply is NOT auto-switching. These means that
you MUST be sure the red Voltage Selector Switch on the back of the
chassis shows the correct voltage for your location.
Before you connect any cables to the expansion chassis, you need to
know the voltage of your power source and slide the Voltage Selector
Switch from 115V to 220V if required. The factory default setting is for
the North American 115V standard. However, most non-US locations
use a 220V standard.
Remove the orange warning label that is covering the plug receptacle.
STOP
Using an incorrect power source (wrong voltage for your system)
can result in serious damage to your system. Electronics
components, damaged by incorrect power, may prevent your
system from working properly and can be expensive to replace.
4
Chapter 2 Hardware Installation