System Should Be Up And Running - Magma CB264 User Manual

M A G M A
NOTE
After you remove the 5V Load Resistor, it is a good idea to place it in
an ESD envelope and save it. If you ever decide to remove the hard
drive, you will need to reinstall the 5V Load Resistor to ensure your
Expansion chassis continues to work properly.
After you have removed the 5V Load Resistor, you need to remove the
hard drive bay brackets to allow for an easy hard drive installation.
Simply turn the chassis over, and remove the four screws on the bottom
of the enclosure that retain the drive brackets.
Once the hard drive brackets have been removed, mount your hard
drive(s) as specified by the manufacturer.
Next, thread the hard drive ribbon cable under the metal bracket that the
backplane is mounted to as shown below.
Finally, reattach the hard drive brackets to the chassis by replacing the
screws. Hard drives require power. Make sure to connect one of the
white power supply tabs to the hard drive.

System Should Be Up and Running

Apply power to the Magma expansion chassis first, then power up the
computer.
14
Chapter 4
rd
Install 3 Party PCI Cards