SECTION
PRODUCT SPECIFICATIONS.....................................................................................................................
CALIFORNIA PROPOSITION 65.................................................................................................................
POWER TOOL SAFETY .............................................................................................................................
TABLE SAW SAFETY .................................................................................................................................
TY...........................................................................................
TOOLS NEEDED FOR ASSEMBLY.............................................................................................................
CARTON CONTENTS..................................................................................................................................
GLOSSARY OF TERMS..............................................................................................................................
ASSEMBLY AND ADJUSTMENTS..............................................................................................................
OPERATION ...............................................................................................................................................
MAINTENANCE...........................................................................................................................................
TROUBLESHOOTING GUIDE.....................................................................................................................
PUSH STICK PATTERN..............................................................................................................................
PARTS LIST.................................................................................................................................................
WARRANTY.................................................................................................................................................
MOTOR
Type ..................................................
Amps .................................................
Voltage ..............................................
Hz ......................................................
RPM (no load) ...................................
Overload Protection ..........................
MITER GAUGE ...................................
RIP FENCE ..........................................
WARNING
!
To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.
This table saw is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt /
15 Ampere time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is
worn, cut or damaged in any way.
Before using your table saw, it is critical that you read and understand these safety rules. Failure to follow
these rules could result in serious injury to you or damage to the table saw.
2009/12
TABLE OF CONTENTS
PRODUCT SPECIFICATIONS
Universal
15
120
60
5000
YES
YES
YES
SAW
Table Size ......................................
Table Extension .............................
Extension Fence Capacity.............
Blade Size .....................................
Arbor Size ......................................
CUTTING PACACITY
Maximum Cut Depth @ 90° ...........
Maximum Cut Depth @ 45° ...........
Maximum Dado Cut Width .............
Maximum Dado Blade Diameter ....
2
PAGE
2
3
3
4
5
7
9
9
11
12
13
23
30
31
33
34
35
40
25 in. x 19-1/2 in.
(635 mm x 495 mm)
Right
24 in. (609.6 mm)
10 in. (254 mm)
5/8 in. (15.9 mm)
3 in. (76 mm)
2-1/2 in. (64 mm)
1/2 in. (12.7 mm)
6 in. (152.4 mm)
Printed in Taiwan