Table of Contents
Advertisement
240 VOLT SINGLE PHRASE OPERATION
WARNING
!
To avoid injury, disconnect the motor from power
source outlet before reconnecting the wire.
The motor supplied with your machine is a dual
voltage, 120/240 volt motor. It is shipped ready-to-run
for 120 volt operation. However, it can be converted
for 240 volt operation, reconnect the motor wire as
the wiring diagram on page 20.
A qualified electrician should do the conversion, or
the machine can be taken to an Authorized Service
Center. When completed, the machine must conform
to the National Electric Code and all local codes
and ordinances.
The machine is converted by re-wiring the motor
for 240 volts, installing a 240 volt plug on the power
supply cord and replacing the switch with one that is
rated for 240 volt operation.
Be sure the 240 volt plug is only used in an outlet
having the same configuration as the plug illustrated
in Fig. 1.
No adapter should be used with the 240 volt plug.
CAUTION
!
In all cases, make certain that the receptacle in ques-
tion is properly grounded. If you are not sure, have a
qualified electrician check the receptacle.
TOOLS NEEDED FOR
ASSEMBLY
Supplied
Hex key
Not Supplied
Phillips screwdriver
Adjustable wrench
12 mm wrench
Combination square
Straight edge
Feeler gauge
(size 0.02 in.)
CARTON CONTENTS
UNPACKING AND CHECKING CONTENTS
Carefully unpack the band saw and all its parts, and
compare against the list below and the illustration
on the next page. With the help of an assistant
place the saw on a secure surface and examine
it carefully.
WARNING
!
●
To avoid injury from unexpected starting or
electrical shock, do not plug the power cord
into a source of power during unpacking and
assembly. This cord must remain unplugged
whenever you are adjusting/assembling
the saw.
●
The saw is heavy and should be lifted with
care. If needed, get the assistance of someone
to lift and move the saw.
●
If any part is missing or damaged, do not
attempt to assemble the band saw, or plug in
the power cord until the missing or damaged
part is correctly replaced.
TABLE OF LOOSE PARTS
ITEM DESCRIPTION
A.
Foot pads & hex nuts
B.
Bag:
Carriage screws
Hex nuts w/ washers
Screw w/ washers
C.
Door knob / hex screw / washer
D.
Stand attachment hardware
Large washers
Hex nuts
Long hex bolts
E.
Sawdust port
Hex bolts
Washers
F.
Trunnion support hardware
Long bolt
Short hex bolts
Hex nut
Table lock knob
Washers
G.
Trunnion support bracket
H.
Table with insert
I.
Power cord bracket
Cross head bolts
Hex key
J.
Band saw with motor
K.
Miter gauge
L.
Top plate
M.
Tool tray
N.
Left / right side plate
O.
Back plate
P.
Door plate
7
QUANTITY
4
16
16
8
1 each
8
4
4
1
2
2
1
2
1
2
2
1
1
2
2
1
1
1
1
1
1 each
1
1
Hide quick links:
Advertisement
Table of Contents
