Porter-Cable 10 IN. (254 MM) JOBSITE TABLE SAW Instruction Manual page 22

4. If adjustment is needed to make the fence parallel to
the groove, do the following:
• Loosen the two screws (3) and lift up on the
handle (2).
•
Hold the fence bracket (4) firmly against the front
of the saw table. Move the far end of the fence
until it is parallel with the miter gauge groove.
•
Tighten both screws and push the handle to lock.
5. If fence is loose when the handle is in the locked
(downward) position, do the following:
•
Move the handle (2) upward and turn the
adjusting nut (5) clockwise until the rear clamp is
snug. Do not turn the adjusting screw more than
1/4 turn at a time.
•
Over-tightening the adjusting screw will cause the
fence to come out of alignment.
WARNING
!
Failure to properly align the fence can cause
"kickback" and serious injury could occur.
Fig. II
4
RIP FENCE INDICATOR ADJUSTMENT (FIG. JJ)
NOTE: The rip fence indicator points to the scale on
the front of the table saw. Measurement shown by the
indicator will provide the user with accuracy up to 1/16
inch (1.6 mm ). Measurement shown is the distance
from the blade to the side of the fence closest to the
blade.
1. To check the accuracy, measure the actual distance
(1) to the side of the rip fence. If there is a difference
between the measurement and the indicator, adjust
the indicator as shown next.
2. Loosen the indicator screw (2). Slide the indicator to
the correct measurement position on the scale, then
retighten the screw (2).
5
1
3
2
Fig. JJ
1
TABLE EXTENSION SCALE POINTER (FIG. KK)
The table extension scale pointer (1) should be at 13-1/2
in. (342.9 mm) on the scale when the extension is in
the closed position. If not, loosen the holding screw (2),
position the pointer over 13-1/2 in. (342.9 mm) and
re-tighten the screw.
Fig. KK
1
2
ADJUSTING CAM LOCKING LEVER (FIG. LL)
If the extension table moves when it is open and locked,
then the cam locking lever (1) may be loose and need
adjustment, therefore, adjustment to the cam locking
lever is necessary. To adjust the locking lever tension,
turn the bar (2) with a 10 mm wrench until it is tightened,
but do not over tighten.
Fig. LL
22
2
1
2
under table view