Porter-Cable 10 IN. (254 MM) JOBSITE TABLE SAW Instruction Manual page 29

6. Use only the correct number of round outside blades
and inside chippers as shown in the dado set's
instruction manual. Blade or chipper must not exceed
1/2 inch (12.7 mm).
7. Check saw to ensure that the dado will not strike the
housing, insert, or motor when in operation.
Fig. dd
WARNING
!
For your own safety, always replace the blade, blade
guard assembly, anti-kickback pawl assembly,
riving knife assembly and table insert after finishing
a dado operation.
Fig. ee
2
1
3
Dado cut
29