Porter-Cable 10 IN. (254 MM) JOBSITE TABLE SAW Instruction Manual page 32

PROBLEM
Material kicked 1. Rip fence out of adjustment.
back from blade. 2. Riving knife not aligned with blade.
3. Feeding stock without rip fence.
4. Riving knife not in place.
5. Dull blade.
6. The operator letting go of material
before it is past saw blade.
7. Miter angle lock knob is not tight.
Blade does not 1. Sawdust and dirt in elevation/tilting
raise or tilt freely. mechanisms.
Blade does 1. Extension cord too light or too long.
2. Low house voltage.
not come up to
speed. Reset
trips too easily.
Machine vibrates 1. Saw not mounted securely to
excessively. workbench.
2. Bench on uneven floor.
3. Damaged saw blade.
Does not make 1. Miter gauge out of adjustment.
accurate 45° and
90° crosscuts.
For assistance with your product, visit our website at www.portercable.com for a list of service centers, or call the
Porter-Cable Customer Care Center at (888) 609-9779.
POSSIBLE CAUSES CORRECTIVE ACTION
1. Align rip fence with miter gauge slot.
2. Align riving knife with blade.
3. Install and use rip fence.
4. Install and use riving knife. (with guard)
5. Replace blade.
6. Push material all the way past saw blade before
releasing work.
7. Tighten knob.
1. Brush or blow out loose dust and dirt.
1. Replace with adequate size cord.
2. Contact your electric company.
1. Tighten all mounting hardware.
2. Reposition on flat level surface.
3. Replace blade.
1. Adjust miter gauge.
32