Setting Up The Monitor; Attaching The Stand; Connecting Your Monitor - Dell 2208WFP User Manual

Back to Contents Page

Setting Up the Monitor

Dell™2208WFP Flat Panel Monitor User's Guide
Attaching the Stand
Connecting your Monitor
Organizing Your Cables
Attaching the Soundbar (optional)
Removing the Stand

Attaching the Stand

NOTE: The stand is detached and extended when the monitor is shipped from the factory.
Place the stand on a flat surface and follow these steps to attach the monitor stand:
1. Fit the groove on the back of the monitor to the two tabs on the upper part of the stand.
2. Lower the monitor so that the monitor mounting area snaps on to or locks on to the stand.
Connecting Your Monitor
CAUTION: Before you begin any of the procedures in this section, follow the
To connector your monitor to the computer perform the following steps/instructions:
Turn off your computer and disconnect the power cable.
l
Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
l
computer. Do not use both cables on the same computer. Use both the cables only when they are connected to two different computers with
appropriate video systems.
Connecting the White DVI Cable
Safety Instructions.