Advertisement
Status and Error Messages
This section contains a list of error messages
shown on the LCD panel, giving a brief
description of each message and suggestions
for correcting the problem. Note that not
every message shown on the LCD panel
indicates a problem.
Calibrating Printer
The printer automatically calibrates itself
when any of its covers are opened and there
is no error inside. This is not an error
message, and will clear itself after a few
minutes. While the printer displays this
message, do not open the covers or turn off
the printer.
Cancel All Print Job
The printer is canceling all print jobs in the
printer memory, including jobs the printer is
currently receiving or printing. This
message appears when the
button has been pressed down for more than
2 seconds.
Cancel Print Job
The print is canceling the current print job.
This message appears when the
Job button has been pressed and released
within 2 seconds.
Can't Print Duplex
The printer has encountered problems
during duplex printing. Make sure you are
using an appropriate type and size of paper
for the Duplex Unit. The problem could also
be a result of incorrect settings for the paper
source you are using. Pressing the Start/Stop
button will print the rest of the print job on
only one side of the paper. Press the
Cancel Job button to cancel the print job.
EPSON AcuLaser C1900 Quick Reference
Check Duplex P-Size
Check Paper Size
Check Paper Type
Cancel Job
Cancel
Check Media Type
Clean Sensor
The paper size loaded in the printer is not
appropriate for the optional Duplex Unit.
Only A4 or letter size can be used.
The paper size setting is different from the
size of paper loaded in the printer. Check to
see if the correct size of paper is loaded in the
specified paper source.
To clear this error, select Clear Warning
from the control panel's Reset Menu. See
"How to access the control panel menus" for
instructions.
The media loaded in the printer does not
match the paper type setting in the printer
driver. Media that matches only the paper
size setting will be used for printing.
To clear this error, select Clear Warning
from the control panel's Reset Menu. See
"How to access the control panel menus" for
instructions.
You have loaded media other than
transparencies when the Paper Type setting
in the printer driver is Transparency. The
printer stops loading to prevent printer
damage. Load transparencies in the
specified paper source, then press the
Start/Stop button.
The sensor inside the printer is dirty. Open
and close the front cover. Automatic
cleaning is performed.
Status and Error Messages (1/7)
Advertisement
