Bogen HFSF1 Installation And Use Manual
  1. Manuals
  2. Brands
  3. Bogen Manuals
  4. Speakers
  5. HFSF1
  6. Installation and use manual

Bogen HFSF1 Installation And Use Manual

High-fidelity, small-footprint speaker
Hide thumbs Also See for HFSF1:
Table of Contents

Advertisement

Quick Links

Download this manual
High-Fidelity,
Small-Footprint Speaker
Model HFSF1
Installation and Use Manual
© 2008 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-2177-01B 1108

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HFSF1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Bogen HFSF1

Summary of Contents for Bogen HFSF1

  • Page 1 High-Fidelity, Small-Footprint Speaker Model HFSF1 Installation and Use Manual © 2008 Bogen Communications, Inc. All rights reserved. Specifications subject to change without notice. 54-2177-01B 1108...

  • Page 2: Product Description

    The HFSF1 features a removable snap-lock input connector, providing easy wire connection for input as well as loop-through to the next speaker. Note: The HFSF1 is not an outdoor speaker. Do not expose the speaker to rain or moisture. The HFSF1 should only be installed by qualified personnel.

  • Page 3: Product Diagrams

    Product Diagrams Front Drawing (grille removed) 1. Bass Tuning Vent 2. Coaxial Driver Assembly 3. Grille Retention Groove 4. Mounting Clamp Screws (×3) 5. Power Tap Selection Switch Front Drawing (grille removed) Side Drawing 6. Metal Back Can 7. Snap-Lock Input Connector 8.

  • Page 4: Installation

    Installation Important Notes The HFSF1 can be installed in a variety of ceiling environments. The use of the TBSF (Tile Bridge Support) accessory may be desired. For suspended ceilings, the use of both the TBSF Tile Bridge and CK10 Safety Cable is strongly recommended to help support and distribute the weight of the speaker.

  • Page 5: Speaker Wiring

    Speaker Wiring All wiring should be done prior to installation and then plugged into the rear of the speaker. Wiring is terminated at a snap-lock input con- nector. There are two positive and two negative terminals to accommodate daisy-chaining of speakers in a system.
  • Page 6 Selecting Power Levels The front-mounted selector switch is used to set the appropriate power level or impedance for your system. Using your fingers or a small, flat- blade screwdriver, turn the knob until the pointer indicates the power level you require. 70V Systems Power setting scales for 70V systems are labeled on the speaker.

  • Page 7: Specifications

    Specifications SPECIFICATIONS HFSF1 Frequency Response (-10 dB) * 78 Hz to 20 kHz LF Driver 4" Polypropylene Cone 3/4 " Polycarbonate Dome HF Driver Sensitivity (1W/1m) * 86 dBspl Dispersion 150 degrees Power Input (Max.) 50W @ 16 ohms; 16W @ 70V Power Settings (in watts) †...

  • Page 8: Limited Warranty; Exclusion Of Certain Damages

    State to State. Products that are out of warranty will also be repaired by the Bogen Factory Service Department – same address as above or call 201-934-8500. The parts and labor involved in these repairs are warranted for 90 days when repaired by the Bogen Factory Service Department.

Table of Contents