Back Panel - Buffalo AirStation WZR-1750DHP User Manual

IP address error.
9 blinks (Red)**:
System error.
Continuously blinking*:
Updating firmware, saving settings, or initializing settings.
* Never unplug the AC adapter while the Buffalo LED is blinking continuously.
** Turn off AirStation, wait for a few seconds, then turn it back on.
*** Because the network addresses of both the Internet port (WAN port) and the LAN port are the same, it is not possible
to establish communication. Change the LAN-side IP address of the AirStation.

Back Panel

1
Access Point/Wireless Bridge Control Switch
This switch changes between access point mode and wireless bridge mode.
AP - access point (or router)
WB - wireless bridge
2
Mode button
If the switch above is in the "AP" position, this button switches the AirStation between router and access point
functionality. If the switch is in the "WB" position, the button has no effect.
3
USB Eject button
To dismount a USB hard drive, hold down this button until the USB LED flashes (about 3 seconds). The USB drive
can then be unplugged safely.
10