Getting Started; When You First Plug In Your Phone; Updating Your Phone; Start Up Screens - Aastra 9133i User Manual

Getting Started

The 9133i must be set up and
configured prior to its first use.
This section describes phone
behavior and start up screens you
may see when the phone is first
plugged in, or when it is restarted.
When You First Plug in Your
Phone
The 9133i automatically begins the
start up sequence as soon as it is
connected. The phone goes
through this process the first time
you plug in your phone and every
time you restart your phone. The
first screen the phone displays is
the Aastra splash screen.
Aastra 9133i

Updating Your Phone

After displaying the Aastra splash
screen, the 9133i checks settings
and looks for new configuration
and firmware updates for the
phone from the server. If a new
update is found, the phone
displays the message "Updating
Config" or "New Firmware". This
may take a few moments while the
phone downloads the latest
updates.
NOTE: New updates to your phone can
be automatically scheduled
from the server. This is set up
on the phone system by your
system administrator and
should be scheduled during
non-business hours or slow call
periods.
Cheking for new
firmware...
Important! Do not unplug or remove
power to the phone while it is checking
or installing firmware.

Start up Screens

After the phone displays the
Aastra splash screen or after
downloading an update, the phone
displays the Idle State screen:
John Burns
9054550055
Jun 8 2:55pm
The basic Idle State screen lists
your name, extension, and today's
date and time. This screen is
shown whenever your phone is not
in use.

Incomplete Config.

If your phone displays a
"No Service" message without any
extension or user name at the end
of the start up sequence instead of
the Idle State screen, this means
your system administrator has not
set up your extension correctly.
Contact your system administrator
for assistance.

No Service

The "No Service" or "Network
disconnected" prompt appears on
the display and the telephone
status light turns on when the
phone is not properly connected to
the network, or the account has not
been configured by the
administrator. The phone also
displays the default time and date
of 12:00am Jan. 1st, 2000. Check
that the cables are tightly
connected to the phone and to the
wall jack. The phone should
automatically detect when the
connection is reconnected and will
display the "Network Connected"
prompt temporarily.
9133i IP Phone User Guide 3